Engineer Nguyen Thanh Hung | ứng viên tìm việc Sản xuất/Vận hành sản xuất tại Hồ Chí Minh

Tên trường: HCMC University of Technology

Giai đoạn: 2015 -2018

Tên khoa: Bachelor Degree

Địa chỉ: Hồ Chí Minh

Ghi chú học tập: Electronic and Communication Technology

Tên trường: Cao Thang Technical College.

Giai đoạn: 2010 -2013

Tên khoa: Associate Degree

Địa chỉ: Hồ Chí Minh

Ghi chú học tập: Automation Technology

Tổ chức: Hop Tam Corporation

Giai đoạn: 22-07-2010 -29-12-2010

Hình thức làm việc:

Chuyên môn:  Install electronic devices for customers  Maintenance and troubleshoot devices.  Set up and implement project for customers.  Consult and support customers to optimize devices.  Contribute ideas to improve products.

Tổ chức: Intel Products Vietnam

Giai đoạn: 07-03-2011 -22-03-2015

Hình thức làm việc:

Chuyên môn:  Coordinate equipment installation/upgrades/simulation with engineering.  Conduct and publish initial investigation reports for excursions. Work with module engineer in DOE, documenting results and implementing improvements that will prevent Quality and Yield issues.  Monitor and create documentations for improving products and optimizing cycle time for the tools.  Monitor availabilities of spare part and prepare parts following PM schedule  Cooperate with ME (Module Engineer) to identify common failed parts and planning for fixing problem.  Verify and feedback to technical training for adjusting spec and relative docs.  Proactively complete and maintain all required safety classes.  Participate in Intel safety programs (Safety walks, good catch utilization, etc)  Follow all safety procedures and escalate safety concerns (e.g. safety audits, spec edits)  Perform advanced troubleshooting/repairs and complex PMs on given equipment  Effectively contain discrepant material based on existing specs and RFC.  Respond to PCS OOC based on the defined RFC.  Demonstrate skill in using hand tools and basic test equipment during troubleshooting  Escalate availability or cost issues with spares and commodities.  Follow equipment escalation procedures  Coached junior technician in support of HPM methods and practices.  Drive CIP through Lean approach across all shifts.  Partner with supplier in resolving escalations  Attend to station controller issues.  Root cause problem resolution  General Process Knowledge of how units flow though the tool and be able to distinguish equipment induced vs process induced defects  Main responsible for all machines/ equipment of Chip Attach Module, DEFLUX, IHS module such as: installation, troubleshooting issue, preventive maintenance, corrective maintenance.

Tổ chức: Pepperl+Fuchs Viet Nam

Giai đoạn: 03-03-2015 -01-06-2015

Hình thức làm việc:

Chuyên môn:  Develop Training package for new products  Deploy Product Diagnostic training for builds  Provide diagnostic and repair solution creation for specific products and take on overall MFR ownership of specific products.  Responsible for diagnostic competence development and support production/repair in any repair related issue.  Leading failure analysis activities for specific products and also repairs WIP ownership of specific products.  Overall the role demands to find solutions for production issues.  Support New Products Introduction and ramp-up.  Coordinate the set up and verification of diagnostics benches with R&D from Germany.  Improve production flow and process.  Monitor the process and coordinate production activities.  Design process instructions for individual products.